A Few Of Our
Clients
| NAC International of Norcross, GA uses
ANSYS/LS-DYNA to analyze the accident conditions that a nuclear spent
fuel transport cask can withstand...............
More details |
| ArvinMeritor designers use INTERNET
TECHNOLOGY to quickly generate and document FEA results in developing
automotive parts such as a stabilizer bar ...............
More details |
| Penn State - Erie & Cybersonics Inc. present
the piezoelectric, coupled-field capabilities of ANSYS/MULTIPHYSICS in
both linear and nonlinear simulations of a piezoelectric transducer assembly
that will be used to drill core samples of rocks on Mars in the 2003 NASA/JPL
Mars Rover Mission ...............
More details |
| Penn State - Erie & ANSYS, Inc. compare
two-dimensional and three-dimensional modeling of a bolted connection using
ANSYS............... More
details |
| Stewart & Stevenson
Services Inc., a designer and builder of off-shore drilling equipment,
saved over 100 hours in analysis time for an oil drill's
tensioner and riser using DesignSpace. They also redesigned API flanges
to better withstand the motion of the drilling ship and pressure from below the
ocean's surface...............More
details |
| Dupont engineers
eliminate rattle in the Porsche Boxter Manifold at the "eleventh hour"
using ANSYS/Mechanical. Using modal analysis at various resonant
frequencies they pinpointed the source of the noise. Then, again using ANSYS,
they were able to redesign the manifold quickly and
efficiently...............More
details |
| DesignSpace helps visionary
Graham Hawkes prepare for "underwater flight" in his most sophisticated
project to date. DesignSpace helped minimize the drag of DeepFlight Aviator's
components and ensured that the craft could withstand nearly 700 PSI of
pressure................More
details |
| HPS Inc., a supplier of seals to
the OEM market, cut at least nine months off its development
cycle for a new seal by simulating its performance in software rather
than testing prototypes. By using analysis software to view the seal's behavior
on-screen, the company was able to predict and correct a problem that otherwise
wouldn't have shown up until a prototype failed...............More details |
| Rubbermaid uses finite
element analysis to accurately simulate how its 20-inch toolbox lid will
perform under stress. The software package from ANSYS also lets designers
perform thousands of simulated handle lift tests prior to running actual
tests.............More
details |
| Optimizing an Underwater Robot
Arm......... The automatic design optimization capabilities of ANSYS helped
increase lifting capacity by 300% and trim more than 300 pounds
from this astronaut training device. More
details |
| Ajay Garg, a senior
mechanical engineer in Dresser-Rand Company's Engine Process Compressor
Division (Painted Post, NY), estimates that the ANSYS approach made it
possible to evaluate the 10 new models in six months compared to
the two to three years testing would have required. More details |
|